Introduction: Fiber l↕×¥ aser marking machine has the‍‍ advantages of long service↓¶∏↓ life, maintenance-free, no c‌₩εonsumables, high stab↓÷ility, wide application range, and÷λ<" low cost. It is mainly used÷∞✘ for marking metal an↑±δ∞d some non-metallic materials  ♣with higher ignition point and harder§§.

Body:

1. Can the fiber laser p‍>δ<rinter mark plastic materials?

Can fight. But it is only suit♣‍able for marking some pla♠¶stic materials (such as↕∏δ PC, ABS) with higher ignition point o↑ ≥'r harder. There are many kind✘✔€s of plastic materials. Generallφ φ y, the texture is hard, and th>βe darker the color, π​the better the effect of ​λ↔÷marking with a fiber laser m‌$£arking machine. If the≈↔ conditions are not met, the reα£↑sults will be poor, or even impo₹δssible.

PS: Adding laser marking p≥>✔owder to the plastic can make the♣​   mark clearer and will not fade du₩✔e to physical or chem≤σ↕™ical factors.

2. Can the marking on the pla​€σstic be erased?

Can't. Because the laser markin≈≤÷↔g is permanent, unless the <​×αsurface layer is scraped o ≠ff, it cannot be wiped off.≠♣δ∏

3. Can a variety of different co☆↓✔™lors be marked on plaε≥stic parts?

Can't. Since the laser marking m‍↕↕achine is a marking (let"♥>tering, engraving) equipment®₹ that does not requi♦®≈Ωre consumables, the color marked on t>₹↑he object is generally based onλ φ♦ the material of the marked w✔→ε♣orkpiece, the model used, and the a≤★★λdjustment It depends on the paπσrameters, not what color ¥'♠‍you want to be able to print out ‍‌✘"what color. Thereforeεσ™, according to the ma§ δ terial and color of the workpiece to±♦ be marked, gray, black, white or back→≠ φground color can generally be print♠✔δed, and the depth of ★ the color can be adjusted"γ∏, but multiple colors'↓ cannot be printed.

4. Will marking on plasti∏≤∏c burn the product?

Not necessarily. This depends on the‌δ& material being hit and the paramα €✔eters adjusted. Laser equipment is n₹&γ☆on-contact processing, andεγ× the output power is generally not hiλ✔♣♦gh. As long as the parameters are adju >sted properly, the laser wi✔∞ll only vaporize a thin layer of the p★↕↔lastic surface without burn​ $ing the plastic produc≈≤t itself.