The cooling methods of laser markiε↔ng machines with high ¶₩>laser power are all βδwater-cooled. For the equipment of the®✔∑ water cooling system, if &₹ "the switching process is incorre"'πct, it will cause the<♥σ♦ phenomenon of no light dur>©↔$ing marking, and in severe caseδ<s, the laser will be burned out.™ ✘₹ The laser is the core component¥≠₹Ω, and the price is not cheap. Therδ∏efore, the correct sw♣™™itching sequence is particularly i♠" φmportant.

Next, Foshan Fulan Laser will te₽'÷ll you about the cor₩☆rect switching sequence of the laser α‍•→marking machine of the wat≤ ♦er cooling system:

Power on:

1. Plug in

2. Turn on the main↑✘✘ switch (pull up)

3, mention "emergency α≥stop"

4. Press "Industrial C"$₩↔ontrol"

5. Turn on the chiller (th ↔​e key and laser power can only be tur®←€≥ned on when the water temperature of th¶∑$₽e water tank reaches 25°C)

6. Open the "key" (hit horizontally®₹)

7. Turn on "Laser"

8. Remove the lens cap

9. Open the marking so&σftware

Shutdown:

1. Close the marking ♣♥±software

2. Turn off "Laser"

3. Turn off the "key♠λ±Ω" (play vertically)

4. Turn off "Industrial Control" ♣←≠↓(computer)

5. Turn off the main switch (p♠♥☆ull down)

6. Turn off the "chiller" (Nα♠ote: After turning off th"₽e power of the laser marking •™$©machine, it is necessary to keep $ the chiller on for about 3 minutes, an>≤÷ d the chiller can be turned →↔∑off after the compre&≤ssor of the laser water cooli&'♦≤ng system stops).

7. Unplug

8. After 5 minutes of sπλhutdown, cover the lens with ∑♦the cover